Industry News

The use method of 15-FOOT HAMMOCK STAND

2022-07-27


15-FOOT HAMMOCK STAND

ALeg X2   BCenter Pole X1     


CUpright Pole with Hook X2          DChain with Attached S-Hook X2

1. Place 2x Leg (A) on the ground, ensuring the elbow pipes are at a 120-degree angle.
2. Align the hole on Center Pole (B) with the spring button on Leg (A). Press the spring button down
and carefully slide the center pole over the button, the spring button will snap through the hole in
the center pole when it is connected. Repeat this step to connect the other leg.
3. Align the hole on Upright Pole (C) with the top spring button of the leg. Press the spring button
down and carefully slide the pole over the button, the spring button will snap through the hole in the
upright pole when it is connected. Repeat this step to connect the other upright pole.

Select an appropriate size hammock (not included) for this stand.
If your hammock is too short to hang on the pre-installed hooks, use the included chains with attached S-hook.
Adjust the length of the chains to tighten/loosen the fit of the hammock.

USE & CARE
• SAFE USE: Never exceed the weight capacity of the stand, 400 lbs.
Swinging, bouncing, jumping or any other excessive movement may result in serious injury including, but
not limited to, the stand tipping over or dislodging the spring buttons causing components to disconnect.
• CHILDREN: Supervise children at all times. Do not allow children to play or sleep in hammocks (not
included) when used with this stand.
• STORAGE: Store the stand indoors when not in use. Cool, dry locations are recommended to prevent
damage that may result from exposure to moisture.
• INSPECTION: Examine the stand before each use to ensure it is assembled correctly and all connection
points are secure.
• CLEANING: Use a soft cloth and warm water to wipe down the stand, if necessary. Wipe away moisture
with a soft, clean cloth.
• SCRATCHES: The powder coating on the stand is tough and durable but even under normal use, some
scratching is inevitable. To prevent excessive rust, wipe scratched areas to remove moisture.
TROUBLESHOOTING
• If the stand seems unstable, make sure it is on a level surface. Also make sure that the components are
assembled correctly and the connection points are secure.

We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies. Privacy Policy
Reject Accept